Audio Technica AT-LP60XBT User Manual

Rotating the platter
1. Using your hands, rotate the platter ten times.
Remove the tie that locks the tonearm and press the tonearm lift button to lift the tonearm. Slowly rotate
the turntable ten times by hand in the direction of the arrow.
You may want to hold the tonearm to prevent it from moving. This step is for resetting the auto
mechanism, getting rid of any twists in the belt and making sure the belt rides smoothly along the drive rim
on the underside of the platter.
Connecting the AC adapter
This product does not have a power switch. A standby current is always running through the product, even when it is
not being used; disconnect the AC adapter from the outlet when not using the product for a long period of time.
1. Connect the AC adapter to the outlet.
Connect the AC adapter to the outlet without removing the cartridge’s protector. If the platter has rotated,
press the STOP button without touching the tonearm, and then wait until the tonearm returns to its original
position.
Wireless/wired connection
You can connect to a speaker, etc. via Bluetooth technology or RCA audio cable.
When using Bluetooth, refer to “Connecting via Bluetooth wireless technology” on p. 6.

Audio Technica AT-LP60XBT Specifications

General

Type	Belt-drive audio turntable
Operation	Fully automatic
Motor type	DC servo motor
Drive system	V-belt
Output level	150 mV
Product color	Black
Wow & flutter	0.25 %
Nominal speeds	33 1/3, 45 RPM
Platter material	Aluminum
Built-in phono preamplifier	Yes
Signal-to-Noise Ratio (SNR)	50 dB
Power supply type	AC
AC adapter frequency	50/60 Hz
AC adapter input voltage	115/230 V
Quantity	1
Cables included	Audio (3.5mm)
USB ports quantity	0

Weight and Dimensions

Depth	373.3 mm
Width	359.5 mm
Height	97.5 mm
Weight	2600 g