Verifit
®
User's Guide Version 3.12
November 2015
5 Networking
Failure to follow operating instructions could place the user or operator at risk.
Connection to a computer network allows screen images to be printed on a network printer or on a shared printer
on a networked PC. Images and underlying data may also be saved to a shared folder on a networked PC. See
Printing and Storing Results for details. The Verifit may also be connected to a single computer using a network
router, switch or hub. Note that sharing data with NOAH is done over this network connection.
Networking requirements
Connection of the Verifit to a computer network requires a Cat 5, RJ-45 cable.
The Verifit can connect to a local area network (LAN) using either automatic or static internet address
assignment. Most home and small-office networks use automatic addressing. These networks have a DHCP
server (Dynamic Host Configuration Protocol). Special-purpose networks might use static address assignment
provided by the network administrator.
Networking setup
Check Networking requirements and connect the Verifit to your network.
1. Press <Setup> and then choose [Network] from the Setup menu.
2. In the Network poster, select [Enable].
3. In most cases, your network will support automatic address assignment (DHCP) and you need only select
[Auto] and click on [Test ].
4. If the test is successful, your computer domain, address and port assignments will be reported.
27
To Next Page
Loading...