Need help?Do you have a question about the AUMA NORM Series and is the answer not in the manual?
General| Housing material | Aluminium |
|---|---|
| Protection class | IP68 |
| Communication interfaces | Profibus, Modbus, Foundation Fieldbus |
| Control | Local and remote control |
| Certifications | CE |
Defines the intended use of AUMA actuators and manufacturer's liability.
Emphasizes qualified personnel for electrical work and adherence to regulations.
Stresses the importance of maintenance for safe operation.
Highlights the criticality of warnings and notes for preventing injury or damage.
Explains pictographs used to highlight safety-relevant procedures and notes.
Instructions on how to attach the ball handle to the handwheel correctly.
Explains how manual operation works via the handwheel and its interaction with motor operation.
Instructions for setting the mechanical end stop for the CLOSED position.
Instructions for setting the mechanical end stop for the OPEN position.
Provides factory settings and adjustment values for mechanical end stops.
Details how to connect cables using the AUMA plug/socket connector.
Explains the purpose and connection of the standard heater to prevent condensation.
Describes the integrated thermoswitch for motor overheat protection and its connection.
Instructions for connecting position transmitters (potentiometer, RWG) using screened cables.
Explains the use of single and tandem limit switches for signalisation and switching off.
Instructions for cleaning sealing faces, checking O-rings, and refitting the cover.
Step-by-step guide to set the limit switches for the CLOSED end position.
Step-by-step guide to set the limit switches for the OPEN end position.
Instructions for setting the potentiometer for remote indication, including fine-tuning.
Detailed procedure for setting the 2-wire and 4-wire current output for position transmission.
Specific instructions for setting the 4-wire 4-20 mA current output for position transmission.
Recommendations for routine maintenance, checks, and lubrication of the actuator.
Guidance on proper disassembly, sorting, and disposal of actuator components.
Information on available AUMA services for maintenance and inspection.
Explains the symbols and abbreviations used in the wiring diagrams.
Provides a wiring diagram for actuators with 1-phase AC motors.
Offers a wiring diagram for 1-phase AC motors with reversing contactor controls.
Presents a wiring diagram for actuators with 3-phase AC motors.
To Next Page
