AUMA SA 16.1 - Push Button Functions Overview; Structural Design and Navigation

6.3.1 Short overview: Functions of the push buttons
FunctionsPush but-
tons
Scrolling within a group
(The triangles in the display show which direction of scrolling is possible)
Change values
Enter figures from 0 to 9
Confirm the selection to go to a new menu/subgroup
Cancel process
C
Return to previous display: press briefly
Change to another group (S, M, D):
●
hold down for approx. 3 seconds until group M0 is displayed.
●
hold down for longer than 3 seconds until group D0 is displayed (thereby,
group M is skipped).
6.3.2 Structural design and navigation
The indications on the display are divided into 3 groups:
●
Group S = Status indications
●
Group M = Menu (settings)
●
Group D = Diagnostic indications
The active group is displayed in the top right corner of the display.
Change from group S to group M:
1.
Press push button C and hold it down for approx. 3 seconds until group M0
appears.
Change from group S to group D:
2.
Press push button C and hold it down until group D0 is displayed.
➥
(Thereby, group M is skipped.)
Return from group M or group D to group S:
3.
Briefly press C .
Scrolling within a group:
4.
Press or .
➥
The triangles in the top left corner of the display indicate which direction of
scrolling (within one group) is possible.
31
SA 07.1 – SA 16.1/SAR 07.1 – SAR 16.1 Control unit: electromechanic
AC 01.1 Intrusive Modbus RTU Operation