1 g, from 10 to 200 Hz
Resistant to vibration during start-up or for failures of the plant. However, a fatigue strength
may not be derived from this. Not valid in combination with gearboxes.
Vibration resistance according
to IEC 60068-2-6
Open-close duty (operating cycles (OPEN - CLOSE - OPEN):
SA 07.1/07.5 – SA 10.1: 20,000
SA 14.1/14.5 – SA 16.1: 15,000
Modulating duty:
1)
SAR 07.1/07.5 – SAR 10.1: 5.0 million modulating steps
SAR 14.1/14.5 – SAR 16.1: 3.5 million modulating steps
Lifetime
Refer to separate technical dataWeight
The lifetime depends on the load and the number of starts. A high starting frequency will rarely improve the modulating accuracy.To
reach the longest possible maintenance and fault-free operating time, the number of starts per hour chosen should be as low as permis-
sible for the process.
1)
12.5 Accessories
AUMATIC mounted separately from the actuator, including plug/socket connector. Connecting
cables on request. Recommended for high ambient temperatures, difficult access, or in case
of heavy vibration during service
Wall bracket
1)
The control voltage of the reversing contactors is interrupted by operating the EMERGENCY
STOP button.
EMERGENCY STOP button
2)
COM-AC. An interface cable is required for the standard infra-red programming interface.Programming software for PC
Cable length between actuator and AUMATIC max. 100 m. Not suitable for version with potentiometer in the actuator. Instead of the
potentiometer, an RWG has to be used.
1)
Only in combination with reversing contactors and AUMATIC AC 01.1 in enclosure protection IP 67 or IP 682)
12.6 Further information
●
Electromagnetic Compatibility (EMC): (2004/108/EC)
●
Low Voltage Directive: (2006/95/EC)
●
Machinery Directive: (2006/42/EC)
EU Directives
68
SA 07.1 – SA 16.1/SAR 07.1 – SAR 16.1 Control unit: electromechanic
Technical data AC 01.1 Intrusive Modbus RTU
To Next Page
Loading...
