AUMA SQ Series User Manual

305.3. Accessories for electrical connection
305.3.1. Actuator controls on wall bracket
315.3.2. Parking frame
315.3.3. DS intermediate frame for double sealing
325.3.4. External earth connection
336. Operation................................................................................................................................
336.1. Manual operation
336.1.1. Manual operation: engage
336.1.2. Manual operation: disengage
336.2. Motor operation
336.2.1. Local actuator operation
346.2.2. Actuator operation from remote
356.3. Menu navigation via push buttons (for settings and indications)
366.3.1. Menu layout and navigation
376.4. User level, password
376.4.1. Password entry
386.4.2. Password change
386.5. Language in the display
386.5.1. Language change
407. Indications..............................................................................................................................
407.1. Indications during commissioning
407.2. Indications in the display
417.2.1. Feedback indications from actuator and valve
437.2.2. Status indications according to AUMA classification
447.2.3. Status indications according to NAMUR recommendation
467.3. Indication lights of local controls
477.4. Mechanical position indication via indicator mark
488. Signals (output signals).........................................................................................................
488.1. Signals via fieldbus
488.2. Status signals via output contacts (digital outputs)
488.2.1. Assignment of outputs
488.2.2. Coding the outputs
488.3. Analogue signals (analogue outputs)
509. Commissioning (basic settings)...........................................................................................
509.1. End stops in part-turn actuator
519.1.1. End stop CLOSED: set
519.1.2. End stop OPEN: set
529.2. Type of seating: set
539.3. Fieldbus address (slave address), baud rate, parity and monitoring time: set
539.4. Switch compartment: open
549.5. Torque switching: set
559.6. Limit switching: set
559.6.1. End position CLOSED (black section): set
559.6.2. End position OPEN (white section): set
569.7. Intermediate positions: set
569.7.1. Running direction CLOSE (black section): set
579.7.2. Running direction OPEN (white section): set
579.8. Test run
579.8.1. Direction of rotation at mechanical position indicator: check
3
SQ 05.2 – SQ 14.2 / SQR 05.2 – SQR 14.2 Control unit - electromechanical
AC 01.2 Intrusive Modbus RTU Table of contents

AUMA SQ Series Specifications

General

Brand	AUMA
Model	SQ Series
Category	Controller
Language	English