315.5.6. Adjustment of analogue output 2
326. Input signals...........................................................................................................................
326.1. Control via Profibus DP
326.2. Control via Modbus RTU
326.3. Binary input signals (digital inputs)
347. Operation................................................................................................................................
347.1. Operation mode OFF
347.2. Operation mode LOCAL
347.2.1. Push-to-run operation or self-retaining Local
357.3. Operation mode REMOTE
357.3.1. Push-to-run operation or self-retaining Remote
367.4. Operation mode EMERGENCY
367.5. Operation mode Disabled
388. Commissioning......................................................................................................................
388.1. Start Commissioning Assistant
388.2. Perform manual commissioning
398.2.1. Type of seating setting via the device menu
408.2.2. Torque seating setting via the device menu
418.2.3. Limit switching setting via the device menu
458.3. Test run
458.3.1. Check direction of rotation at hollow shaft/stem
468.3.2. Check limit switching (Combi-Switch version)
468.3.3. Check limit switching (magnetic pen control panel version)
479. Date and time..........................................................................................................................
4810. Display formats......................................................................................................................
4810.1. Date format
4810.2. Time format
4810.3. Number format
4810.4. Torque unit
4810.5. Temperature unit
4910.6. Position units
4910.7. Process factor units
5010.8. Analogue working value units (AIN)
5110.9. Analogue signal output units (AOUT)
5211. Contrast...................................................................................................................................
5312. Application functions.............................................................................................................
5312.1. Profibus DP interface
5312.1.1. Bus address (slave address)
5312.1.2. Redundancy
5312.1.3. Response telegrams for AUMA redundancy II
5412.1.4. Connection type – compatibility with process representation
5412.2. Modbus interface
5412.2.1. Bus address (slave address)
5412.2.2. Baud rate
5412.2.3. Parity/stop bit
5512.2.4. Monitoring time
5512.2.5. Response timeout
3
Multi-turn actuators
TR-M30X – TR-M1000X Table of contents
To Next Page
Loading...
