AUMA TIGRON TR-M30X - Page 4

5512.2.6. Redundancy
5512.2.7. Response telegrams for AUMA redundancy II
5612.3. Intermediate positions
5612.3.1. Define the pivot points of intermediate positions
5612.3.2. Set signal behaviour of intermediate positions
5712.3.3. Hysteresis for intermediate positions: set
5812.4. Positioner (operation mode REMOTE SETPOINT)
5912.4.1. Activate positioner
5912.4.2. Activate/deactivate adaptive behaviour
6212.4.3. Set overrun (inner dead band) manually
6312.4.4. Set max. error variable (outer dead band) manually
6312.4.5. Set the dead time
6312.4.6. Set hysteresis for positioner
6412.4.7. Closing fully/opening fully (end position tolerance for setpoint)
6412.4.8. Limit setting range
6512.4.9. Change-over between OPEN-CLOSE control and setpoint control
6512.4.10. Input of setpoint position: Parallel interface
6612.4.11. Input range of setpoint position: Parallel interface
6612.4.12. Input of setpoint position: Profibus DP
6612.4.13. Input range of setpoint position: Profibus DP
6712.4.14. Input of setpoint position: Modbus RTU
6712.4.15. Input range of setpoint position: Modbus RTU
6712.5. Stepping mode
6812.5.1. Activate stepping mode
6812.5.2. Operation mode for stepping mode
6912.5.3. Start and end of stepping mode
6912.5.4. On times and off times
6912.6. Additional inputs for fieldbus
7012.7. Combination of fieldbus-parallel interface
7112.8. Auto change-over I/O (during fieldbus failure)
7213. Failure functions....................................................................................................................
7213.1. Safety parameters
7213.1.1. Safety tripping
7313.1.2. Set failure source (failure reason) for a failure operation
7313.1.3. Failure operation (reaction of the actuator) on loss of signal
7413.1.4. Failure position
7413.1.5. Safety delay setting
7513.2. Emergency parameters and EMERGENCY behaviour
7613.2.1. Activate EMERGENCY behaviour
7613.2.2. Emergency tripping
7713.2.3. Set failure source (failure reason) for an EMERGENCY operation
7713.2.4. EMERGENCY operation
7813.2.5. Emergency position
7813.2.6. Set Emergency delay
7813.2.7. Operation mode for EMERGENCY behaviour
7813.2.8. Bypass stepping mode
7913.2.9. Bypass Interlock
7913.3. Enabling local controls
8013.3.1. Activate enabling function
8013.3.2. Enabling function behaviour
4
Multi-turn actuators
Table of contents TR-M30X – TR-M1000X