LIUSK8B00_eng-01AUTEC
19
Signals Meaning
The green LED and the red LED are eady on at
Radio Remote Control's art up and an acouic
signal sounds.
Wrong Key ID 0-1 or ID internal tx memory has
been inserted in the Transmitting Unit.
You're using a BACK-UP UNIT with the Key ID 0-1
or ID internal tx memory of the Transmitting Unit
that has been replaced.
The green LED and the red LED blink three times
per second at Radio Remote Control's art up.
The Key ID 0-1 or ID internal tx memory is
damaged.
The green LED is eady on and the red LED blinks
twice per second at Radio Remote Control's art
up.
START is active.
The green LED] and the red LED blink alternating.
30s left before the Transmitting Unit automatically
switches off.
The green LED repeats the sequence three blinks
and a pause, and the red LED is eady at Radio
Remote Control's art up.
The UNPAIR procedure has been carried out.
The green LED and the red LED are off at Radio
Remote Control's art up
The GSS or the EMS pushbutton is pressed.
The power keyswitch is not inserted.
The battery is completely discharged or not
inserted.
7.1.2 Battery icon
The display on the SK8B Transmitting Units has a Battery icon [D] that provides indications
related to the battery charge level.
The Battery icon [D] shows a bar whose length and colour indicate the battery power level.
Symbol Meaning
High power level (green bar).
Medium power level (green bar).
Low power level (green bar): the battery has less than 1h run time from the beginning
of this signal.
Very low power level (red bar): the battery has 10min run time from the beginning of
this signal.
The Unit is about to switch off (blinking red bar): the battery has 2min run time from the
beginning of this signal.
To Next Page
Loading...
