Autel MaxiCharger - Power Supply Wiring

35
4.4 Power Supply Wiring
IMPORTANT
 Consult the local electrical codes for the correct
wire size, based on the environment, the
conductor type, and the rating of the charging
station.
 Ensure that all the screws are tightened to the
correct torque after the wiring is completed,
and that there are no loosen screws at the
terminal blocks.
 Ensure there is no copper wire or debris left
inside of the charging station before switching
on the electrical power to the charging station.
NOTE
The three-phase charging stations also accept
single-phase wiring. Refer to the Three-phase
wiring instructions to connect the L1, N, and PE
wires to the corresponding terminals accordingly.