15
Duplicated.”. In One Wheel mode, the tool will not check the duplication of
sensor ID.
Power-off
1) From System Setting screen, use the UP/DOWN scroll button and
LEFT/RIGHT scroll button to select Power-off, and press the Y button.
2) Press the UP/DOWN scroll button to increase or decrease the interval
time for auto power-off, and then press the Y button to confirm your
change or the N button to exit without change.
Figure 3-12
NOTE
1. Before the tool powers off automatically, it will save all the TPMS test
data. Next time when the tool is powered on, you may retrieve the
recorded data or return to the last operation.
2. When using external power, the scan tool stays on until you turn it off.
When using internal battery power, the scan tool turns off automatically
after a set time of inactivity.
Date
This function allows setting the date information of the tool.
1) From System Setting screen, use UP/DOWN scroll button and
LEFT/RIGHT scroll button to select Date, and press the Y button; wait
for the Date screen to appear.
2) Use UP/DOWN scroll button to increase or decrease the value and
LEFT/RIGHT scroll button to select the item need to change.
To Next Page
Loading...
