26
[ID-H/D] – shows sensor ID data.
[kPa/Psi/Bar] – indicates tire pressure.
[°C/°F] – indicates tire temperature.
[BAT] – indicates battery condition.
[Mode] – defines tire sensor working mode or status.
[Modulation] – indicates sensor signal amplitude.
NOTE
Different ID format, pressure and temperature units will display at the title
bar according to the device’s system setting, please refer to System Setting
on page 9 for detailed instruction.
Select by Latest Test
This function allows you to review the last tested sensor data and activate
the sensor by using the wave signal of the latest trigger event, which is very
convenient and useful for technicians to wake up sensors of the same
vehicle.
1) Use the UP/DOWN scroll button and LEFT/RIGHT scroll button to
select Latest Test from Main Menu.
2) An activation screen with the previously activated sensor information
will show up (Figure 4-15). Use the UP/DOWN or LEFT/RIGHT scroll
button to select the desired wheel, and press the TEST button to
reactivate the sensor, or press the Y button to view all detailed sensor
data (Figure 4-16).
Figure 4-15
To Next Page
Loading...
