31
2. If there are untested sensors in the vehicle, the writing ID process
cannot proceed. The tool will display a warning message as below. In
this case, follow the sensor check procedure to activate all sensors in
vehicle and register sensor IDs again.
Figure 4-24
NOTE
1. If duplicate IDs present, the writing ID process cannot proceed. In this
case, follow the sensor check procedure to activate all sensors in
vehicle and register sensor IDs again.
2. Make sure to turn the ignition off before connecting/disconnecting the
OBD II Cable to/from the TPMS tool; otherwise it may cause the
Malfunction Indicator Light (MIL) to turn on.
Read IDs from Vehicle
1) From TPMS Diagnosis Menu, use the UP/DOWN scroll button to
select the Read IDs from Vehicle, and press the Y button.
2) The tool will display the sensor IDs and positions for viewing. Select
Save to store data for future review, or Esc to exit without saving.
Figure 4-25
To Next Page
Loading...
