Autic System Marine PC Rev. 1.1 Page 57
BOOT SCREEN
This section displays the available devices on your system for you to configure the boot settings and the boot
priority by setting Boot Option #1, #2 and #3 etc.
FAST BOOT
Fast Boot minimizes your computer’s boot time. There are three configuration options: [Disabled], [Fast] and
[Ultra Fast]. The default value is [Disabled]. Please refer to below descriptions for the details of these three
options:
[Disabled] - Disable Fast Boot.
[Fast] - The only restriction is you may not boot by using an USB flash drive.
[Ultra Fast] - There are a few restrictions:
Only supports Windows
®
8 64-bit UEFI operating system.
You will not be able to enter BIOS Setup (Clear CMOS or run utility in Widows
®
to enter BIOS Setup).
If you are using an external graphics card, the VBIOS must support UEFI GOP in order to boot.
BOOT FROM ONBOARD LAN
Use this item to enable or disable the Boot from Onboard LAN feature.
SETUP PROMPT TIMEOUT
This shows the number of seconds to wait for setup activation key.
BOOTUP NUM-LOCK
If this item is set to [On], it will automatically activate the Numeric Lock function after boot-up.
BOOT BEEP
Select whether the Boot Beep should be turned on or off when the system boots up. Please note that a buzzer
is needed.
FULL SCREEN LOGO
Use this item to enable or disable OEM Logo. The default value is [Enabled].
To Next Page
Loading...