Autic System Marine PC Rev. 1.1 Page 58
CSM (COMPATIBILITY SUPPORT MODULE)
CSM
Enable to launch the Compatibility Support Module. Please do not disable unless you’re running a WHCK test.
If you are using Windows
®
8 64-bit and all of your devices support UEFI, you may also disable CSM for faster
boot speed.
EXIT SCREEN
SAVE CHANGES AND EXIT
When you select this option, it will pop-out the following message, “Save configuration changes and exit
setup?” Select [OK] to save the changes and exit the UEFI SETUP UTILITY.
DISCARD CHANGES AND EXIT
When you select this option, it will pop-out the following message, “Discard changes and exit setup?” Select
[OK] to exit the UEFI SETUP UTILITY without saving any changes.
DISCARD CHANGES
When you select this option, it will pop-out the following message, “Discard changes?” Select [OK] to discard all
changes.
LOAD UEFI DEFAULTS
Load UEFI default values for all the setup questions. F9 key can be used for this operation.
To Next Page
Loading...