AutoCrib RoboCrib 2000 E - Problem: Open Door error message or LED does not turn on when door is open; Test all doors using Console screen; Manually test the doors

Troubleshooting
32 | P a g e
Problem: Open Door error message or LED does not turn on when door is open
1. Test all doors using Console screen
 Login to the RoboCrib software as a supervisor and select the Console button.
 Actuate each individual door by using the LON ## command (## - Representing the door number)
 If all LED lights turn on when the door opens, continue troubleshooting steps. Otherwise, use the
spare door provided with the RoboCrib.
2. Manually test the doors
 Turn the controller off.
 Remove the left door screws and open the left door.
 Detach the ribbon cable from door 1.
 Turn the controller on.
 Verify the door switch is in the Run position.
 Restart the RoboCrib software. If the machine calibrates successfully, the faulty door has been
located. Replace this door with the spare provided with the RoboCrib.
 If the RoboCrib cannot calibrate, continue with the steps below.
o Turn the controller off.
o Reattach the ribbon cable to the door.
o Unplug the next door.
o Turn the controller on.
o Restart the RoboCrib software. If the machine calibrates successfully, the faulty door has been
located. Replace this door with the spare provided with the RoboCrib.
o If the RoboCrib cannot calibrate, continue with steps (i) through (v) to find the problematic door.