Technical Specifications
35 | P a g e
RoboCrib Technical Specifications
RoboCrib External Parts
- Frame
o A 2” steel tube frame supports a chain drive system, which actuates 12 individual platters.
o The frame is 62” wide, 62” deep, and 83” high (including wheels).
- Wheels
o Omni-Directional
o Non-Locking
o Leveling footpads are included with the shipment of the RoboCrib if using the wheels is not preferred.
- Walls
o Made from 16Ga steel
o Sit in a channel, lock together with interlocking tabs, and attach to the frame by pin-in-hex tamper-
resistant screws.
o Types of Walls:
Right Front and Left Rear corner panels (2 each)
Right Rear and Left Front corner panels (2 each)
Back Panels (2 each)
Front Bin Door Panel (1 each)
Vertical Z Channel (2 upright rack mount rails) which holds the:
Control Panel
Touch screen Assembly
RoboCrib Platters
- Main Platter (MP)
o Large Center Platter
o 4‟ 8” diameter
o Driven by the main platter motor and chain
- Large Sub Platter (LSP)
o Three platters each with 3 small sub platters
o 1‟ 8” diameter
o The LSP motor and chain drive the 3 large sub platters and the 01X, 02X, and 03X small sub platters.
o The LSP chain is also called the “serpentine” chain.
- Small Sub Platters (SSP)
o Nine 10” diameter sprockets
o Located on the three large sub platters
To Next Page
Loading...
