AUTOFLAME Mk8 MM - Page 53

Lockout Message Description
82 Purge Pressure Proving Input Input on T81 read high during relay test phases
 Input has been made before the blower starts; it should only be made continuously during purge.
 Check wiring on terminal 81.
198 BC Input Short Internal fault
 Contact Autoflame approved local tech centre
199 Lockout 199 Internal fault
 Contact Autoflame approved local tech centre
200 Lockout Cleared Lockout has been cleared
 MM status after lockout has been reset (Modbus)
201 Power up CPU Test Fail Internal check failed
 Contact Autoflame approved local tech centre
202 Power up EEPROM Test Fail Internal check failed
 Contact Autoflame approved local tech centre
22.05.2017 Mk8 MM End User Guide Page 48
4 Errors and Lockouts