Owner Installation Instructions GDO-6v3 EasyRoller
®
7
SmartSolar™ and Battery Back Up Compatibility (optional)
The opener can be fi tted with a SmartSolar™ or Battery Back Up kit for operation in
the event of a power outage, or where mains power access is not available. NOTE: If
the door is the only entrance to the garage, and a battery back up kit is not fi tted,
a keyed cable release should be fi tted external to the garage.
Vacation mode
A hand held transmitter can be programmed to lock and unlock all other
transmitters that have been programmed into the openers’ memory. The vacation
mode can be used when the door is left idle for long periods of time.
Pet/Pedestrian mode
The transmitter can be programmed to open the door to an adjustable partial height
so that the family pet can enter and exit the garage at any time. You may also wish to
open the door to a height suitable only for pedestrian access.
Auto-close mode
The opener can be programmed to automatically close after an open cycle. The auto-close
time is adjustable. It is compulsory to install a P.E. Beam if this mode is selected, otherwise the
door may cause personal injury or damage to property.
Photo Electric (P.E.) Beam (optional)
The opener has an input to connect a P.E. Beam for extra safety and use of the auto-close mode. We highly
Manual operation
The opener is equipped with a unique manual disengaging device. If the power to the opener is disrupted the
door can be put into manual mode by pulling down on the string handle on an angle towards the door. This
allows for manual operation of the door. To re-engage the opener pull the string handle away from the door.
Easy Access Transmitter
Inside the manual release handle is a transmitter designed to be in easy reach so that the garage door can be
operated without having to stretch to reach the operate button on the control panel.
recommend that Photo Electric Beam be installed.
To Next Page
Loading...
