4 Maintenance
4-7
4
4.2 Maintenance Procedure
4.2-1 Equipment replacements and checks
Temperature control (Omron brand)
Note! Temperature controller is used on both wrapper and shrink tunnel.
Setting For E5CN
Indicators
Operation indicators: Used to show the status of output, alarm etc.
Temperature unit: This shows the selectable unit value from controller.
Display 1: Indicates the running Process Value for temperature.
Display 2: Indicates the Set point Value for temperature.
Setting keys
Up key: Used to increase the set point value.
Down key: Used to decrease the set point value.
Mode key: Used like Enter button and goes to next value. Its also used in
combination with level key.
Level key: Used to change the setting level.
To Next Page