4 Maintenance
4-29
4
8 - Pneumatic system (TxE tunnels)
ASU
Check oil,water,primary & secondary pressure,lube rate (look
Check oil feed rate. Check for oil near exhausts)
Valves- check for leaks, check coils are screwed on
9 - Electrical system
Control Panel
Fuses-corect value
Phase currents-correct value
Temp control-correct Time cycling = more than 6 sec ,setting
Check contactors for Browning on top (if used), check wire terminations for burning,
etc.
Junction boxes - check screws are tight, check Glands are tight, check name labels
are there
To Next Page
Loading...