AUX Air Conditioner Service manual
10
⑤ Temp increasing button （⑤）
Press the button once , the setting temperature increases 1℃ .
Press the button continuously for more than 1 second . the setting temperature increases at the
speed of 4℃/s . the highest setting temperature is 32℃ .
⑥ Select button for operation mode （⑥）
Which enables you to select different operation modes . after each pressing , the operation
mode will be changed . It shows in the following display .
Remark: Cold wind type has no heating function
⑦ Cancel button （function conformity,⑦accordingly）
YK(R)-C/01E
This button have the function of canceling the timer time .
⑧ Set button （function conformity,⑦accordingly）
When press the SET button . the function of adjusting clock time or affirming the timer time can
be set .
⑨ Time setting button ⑨
YK(R)-C/01E
These two buttons can adjust clock time and timer time . Press it for 1 to 5 seconds , time display
will change at the change at the speed of three times per second (Unit : 10 minute) . After 5
seconds , it will change at the speed of ten times per second (Unit : 10 minute) .
YK(R)-C/02JE
These two buttons can adjust clock time and timer time . Press it for 1 to 5 seconds , time display
will change at the change at the speed of two times per second. For 5 to 10 seconds , it will
change at the speed of ten times per sec .(Unit : 1 minute). For more than 10 seconds , it will
change at the speed of ten times per second too . (Unit : 10 minute) .
⑩ Timing ON/OFF button （⑩）
Set the Timing mode . After each pressing , the mode will be changed . It shows in the following
display .
○
11
ON/OFF button （○
11
）
You can start the air-conditioner by pressing this button and stop its operation by pressing it
again .
Model of YK（R）-C/02JE Particular function description as follows
② Health button
Pressing this button , the LCD shows the “ ” symbol , the anion emission function of the ai
To Next Page