To Next Page

To Previous Page

AUX Air Conditioner Service manual

The opening state of remote controller:

① “+” button

This button not only can adjust clock time and the time

time but also can set room humidity.

Adjusting clock time and timer time

Press it once ,the time increases one minute. Press it for 1 to

3 seconds, time display will increase at the speed of 2min/s.

For 3 to 5 seconds, it will increase at the speed of 10min/s.

For more than 5 seconds, it will increase at the speed o

10min/s.

Setting room temperature and room humidity

Press it once ,the humidity increases 5%.

② “HEALTH” button

Press this button ,the LCD shows the

“”

symbol, the

anion emission function of the air conditioner is started.

Press the button once again, The

“”

symbol

disappears, the function is cancelled at the same time.

③ “SLEEP” button

Press this button ,the LCD shows the symbol, the sleeping function of the air conditioner is started.

After 7 hours of setting this function ,the air conditioner will be off automatically.

Press the button once again, The

symbol disappears, the function is cancelled at the same time.

This function is invalid when the appliance under the Fan mode.

④ “POWER” button or “POWER/QUIET” button

★

When it displays “POWER” button :

Press this button, the fan speed reach the highest , press it again it resume the foregoing fan speed.

★ When it displays “POWER/QUIET” button :

Which enables you to select different operation mode , after each pressing , the operation mode will be

changed . It shows in the following display .

This function is only suitable for frequency variable appliance .

⑤“HUMIDITY” button

Only under the mode of Heat and Fan, Press this button once , the LCD shows the symbol, the wetting

function of the air conditioner is started. The initial humidity is 60%. Press the ”+” or “-“ button once , the

humidity increases or decreases 5%. The setting range is 30%~60%.

AUX EA Series User Manual

Questions and Answers: