AUX Air Conditioner Service manual
14
1. Press the TIMER button. select the “Timer OFF”. the remote controller display “ ” ; “ OFF ”
displays intermittently.
2. Adjust time through pressing the or button.
3. Press the SET button then. the setting is finished.
Remark: The remote controller can be set 24 hours.
★ Sleeping operation mode
1. Press the “ ” button. the sleeping indicator light of indoor unit flashes on.
2. After the setting of sleeping mode. the cooling operation enables the set temperature to increase 1℃
after 1 hour and another 1℃ automatically after 1 hour.
3. After the setting of sleeping mode. the heating operation enables the set temperature to drop 2℃
after 1 hour and another 2℃ automatically after 1 hour.
4. The air-conditioner runs in sleeping mode for 7 hours and stops automatically.
Remark: Press the MODE button or ON/OFF button. the remote controller clears sleeping mode away.
Model: YK(R)-C/01E
★ Fix batteries
1. Slide open the cover according the direction indicated by arrowhead.
2. Put into two brand new batteries (7#). position the batteries to right electric poles (+&-).
3. Put back the cover.
Make sure to connect the wire to independent power source socket before you use the remote
controller.
Note: the waste battery shall be disposed properly.
★ Automatic operation mode
1. Press the MODE button. select the automatic operation mode.
2. Press the “ ” button. you can select fan speed.
The type of H、M series:
You can select fan speed from “Power”. “High”. “Low”. “Mute”.
The type of E series:
You can select fan speed from “Auto”. “High”. “Mid”. “Low”.
3. Press the “ ” button. the operation indicator is on. the air-conditioner starts to operate the
Automatic mode.
Press the button again. the air-conditioner stops.
★ Cooling / Heating operation mode (Cold wind type has no heating function)
1. Press the MODE button. select the Cooling or Heating operation mode.
2. Press “ ” or “ ” the button. set the temperature. temperature can be set at 1℃ difference range
To Next Page