Avantik QS11 - 3-3 Specimen coarse feed and trimming stages

Avantik Cryostat QS11 / QS11UV
Avantik
36 Commerce St.
Springfield NJ 07081 / USA
387 779 - English
49
3-3 SPECIMEN COARSE FEED
AND TRIMMING STAGES
After changing the specimen, moving the knife
or knife carrier, it is necessary to adjust the
specimen to the knife edge again. This can
easily be done by means of the specimen
coarse feed and the defined trimming values.
To move the specimen holder electronically
forwards or backwards, use the corresponding
buttons on the operating controls.
After the specimen and knife are adjusted,
further gradual feed for trimming can be
carried out by using the function <trimming>.
Whenever pressing the button <trimming>, the
motorized feed is released. The same
happens, when the function <trimming> is
stored and
the handwheel is turned.