Avantik Cryostat QS11 / QS11UV
Avantik
36 Commerce St.
Springfield NJ 07081 / USA
387 779 - English
28
2-5-2 MEMORY FUNCTION
The memory function allows the automatic
approach between specimen and knife.
It is used to find again the first cut position in a
very fast way.
This function can only be used on condition
that blocks, which have been embedded in the
same molds, are cut. The blocks must have
almost the same height.
To set the first cut position, please proceed as
follows:
• Press the memo button (fig. 19.1) in the
desired position until the LED briefly lights
up in this button.
• The position is now stored.
• The following message is shown on the
display (fig. 19.2): POS.
• Press the memo button (fig. 19.1) again to
move to this stored position later on.
Fig. 19
MEMO
CHAMBER TEMPERATURE ° C
DOWN
DEFR
TIME
INTER
RUPT
UP
P
2
1
To Next Page
Loading...
