Avantik Cryostat QS11 / QS11UV
Avantik
36 Commerce St.
Springfield NJ 07081 / USA
387 779 - English
53
4-5 SECTIONING AND TAKING
OFF SECTIONS
For sectioning, pre-select the desired section
thickness by means of the buttons on the
operating controls. Put the anti-roll plate
against the knife by means of the knob. Turn
the handwheel in a clockwise direction to carry
out sectioning. The section slides into the
space between the knife and the anti-roll
guide.
Then remove the anti-roll guide by means of
the knob. The section sticks to the knife
surface. Transfer the specimen now onto a
slide by using a brush or tweezers.
To Next Page
Loading...
