6. Select one of the following:
• Work number
• Mobile number
• Other number
• Ring signal
7. Press Add.
8. Enter the numbers.
The administrator can add a variable or the character “U” to the Work number, Mobile
number, or Other number field to allow users to enter additional numerical characters
before calling the number.
You can set a specific ring signal for each contact.
9. Press OK.
10. Press Save.
Adding a contact from the call list
Procedure
1. Press Menu.
2. Select Contacts.
3. Select Add contact > From call list, and then select a number from the call list.
4. Press Add.
5. Select any of the following:
• Work number
• Mobile number
• Other number
• Ring signal: You can set a specific ring signal for each contact.
6. Press Add.
7. Enter the name for the contact, and then press OK.
8. Press OK.
If the Force stimuli ringing is enabled, the handset uses the system-provided ring signals
instead of the local ring signals. This function is applicable in legacy systems only (stimuli).
9. Press Save.
Editing a contact
About this task
Use this procedure to edit local contacts.
Managing contacts
August 2019 Using 3735 DECT handsets with Communication Manager and IP Office 79
Comments on this document? infodev@avaya.com
To Next Page
Loading...
