4. Set the default gateway IP address.
ip default-gateway <A.B.C.D>
5. Save the configuration.
save config
Variable definitions
Use the data in the following table to use the ip address command.
Table 5: ip address command
Variable Value
<A.B.C.D> Set the management IP address.
netmask <A.B.C.D> Set the subnet mast IP address.
Use the data in the following table to use the ip default-gateway command.
Table 6: ip default-gateway command
Variable Value
default-gateway <A.B.C.D> Set the default gateway IP address.
Value of IP address ranges from 0.0.0.0 (no IP address assigned) to 255.255.255.255. For
more information on IP addressing and subnet addressing, see Configuration — IP Routing
and Multicast Avaya Ethernet Routing Switch 4000 Series (NN47205-506).
Configuring BootP on the current instance of the switch or
server
About this task
The default operational mode for BootP on the switch is BootP or DefaultIP. The switch
requests an IP address from BootP only if one is not already set from the console terminal (or
if the IP address is the default IP address 192.168.1.1).
Procedure
1. Enable Global Configuration mode in ACLI:
enable
configure terminal
Configuring the switch using ACLI
26 Quick Start Configuration for Avaya ERS 4000 Series November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
