Installing a license file
This procedure is used to install a license file. If the switch is reset to default, the license file
must be reinstalled and to reenable licensed features. Resetting a switch to default removes
the license file from its storage area in NVRAM. Store the license file on a TFTP server
accessible by the switch or stack before starting the installation procedure. For switches
equipped with a USB port, you can also use a USB mass storage device to copy the license
file to the switch.
About this task
Install a license file on Avaya Ethernet Routing Switch 4000 to enable licensed features.
Procedure
1. Log on to Privileged EXEC mode in ACLI:
enable
2. Install a license file:
copy [tftp | usb] license <tftp_ip_address> filename
<license_file_name>
3. Restart the switch.
Example
Installing a license using USB example
1. Insert a USB mass storage device into a USB port on the front of the switch.
2. To copy a license from a USB mass storage device, use the following commands:
4850GTS-PWR+>enable
4850GTS-PWR+#copy usb license 4500_adv.lic
The switch generates the message: License successfully downloaded
Important:
You must reboot the system to activate the license.
Configuring the switch using ACLI
50 Quick Start Configuration for Avaya ERS 4000 Series November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
