Avaya 4000 Series - Dynamic ARP inspection

sntp server secondary address [<A.B.C.D> |
<secondary_server_ipv6address>]
Note:
SNTP supports primary and secondary NTP servers. The system tries the
secondary NTP server only if the primary NTP server is unresponsive.
4. Enter the following command to enable SNTP:
sntp enable
Variable definitions
The following table describes the parameters for the sntp server command.
Variable Value
<A.B.C.D> Enter the IP address of the NTP server.
<primary_server_ipv6address> Enter the IPv6 address of the primary NTP
server.
<secondary_server_ipv6address> Enter the IPv6 address of the secondary NTP
server.
Configuring local time zone
About this task
Configure the time zone to use an internal system clock to maintain accurate time. The time
zone data does not include daylight changes. You need to configure daylight savings.
Procedure
1. Enter Global Configuration Mode in ACLI:
enable
configure terminal
2. Enter the following command to enable SNTP:
sntp enable
3. Configure the time zone by using the following command:
clock time-zone zone hours [minutes]
4. Configure daylight savings using the following command:
Configuring local time zone
Quick Start Configuration for Avaya ERS 4000 Series November 2013 37