For more information about the supported browsers, see Using ACLI and EDM on Avaya
Ethernet Routing Switch 4000 Series, NN47205-102
About this task
Monitor the switch through a Web browser from anywhere on the network. By default, the Web
interface uses a 15 minute time-out period. If no activity occurs for 15 minutes, the system logs
off the switch Web interface, and you must reenter the password information.
To configure inactivity time-out, see Configuring Systems on Avaya Ethernet Routing Switch
4000 Series, NN47205-500.
Procedure
1. Start your Web browser.
2. Type the switch IP address as the URL in the Web address field.
http://<IP Address>
https://<IP Address>
3. Enter the user name.
4. Enter the password.
5. Click Log On.
Configuring a VLAN
Use this procedure to create a VLAN using ACLI. Optionally, you can choose to assign the
VLAN a name.
For more information on configuring a VLAN, see Configuring VLANs, Spanning Tree, and
Multi-Link Trunking on Avaya Ethernet Routing Switch 4000 Series, NN47205-501.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To create a VLAN, enter the following command at the command prompt:
vlan create <VID_list> [name <LINE>] type { port { voice-vlan
| remote-span | [<1-8>] { voice-vlan | remote-span } } |
protocol decEther2 | protocol-ipEther2 | protocol-ipv6Ether2
| protocol ipx802.2 | protocol-ipx802.3 | protocol-ipxEther2
| protocol ipxSnap | protocol-Netbios | protocol-RarpEther2 |
protocol sna802.2 | protocol-snaEther2 | protocol-vinesEther2
Configuring the switch using ACLI
44 Quick Start Configuration for Avaya ERS 4000 Series November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
