Variable definitions
The following table describes the parameters for the clock source command.
Variable Value
ntp Configure NTP as time source
sntp Configure SNTP as time source
sysUpTime Configure System Up Time as time source
Configuring static route
Create static routes to manually configure a path to destination IP address prefixes.
Procedure
1. Enter the Global Configuration command mode:
enable
configure terminal
2. Enable IP routing globally.
ip routing
3. Configure IP address on a VLAN.
ip address <ip address> <mask> [<MAC-offset>]
4. Configure a static route.
ip route <destination ip> <mask> <next-hop> {<cost> | disable
| enable | weight <cost>}
5. Display all the static routes.
show ip route static [<dest-ip>] [-s <subnet> <mask>]
6. Save the configuration.
Variable definition
Use the data in the following table to use the ip route command.
Configuring the switch using ACLI
40 Quick Start Configuration for Avaya ERS 4000 Series November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
