Enabling logging
Use this procedure to enable the logging of system messages. For more information about
logging, see Avaya Ethernet Routing Switch 2500, 4000, and 5000 Series Logs Reference
(NN47216-600).
Procedure
1. Enter Global Configuration mode in ACLI:
enable
configure terminal
2. To enable system log, enter the following command at the command prompt:
logging remote level informational
Configuring Simple Network Time Protocol
The Simple Network Time Protocol (SNTP) feature synchronizes the Universal Coordinated
Time (UTC) to an accuracy within 1 second. This feature adheres to the IEEE RFC 2030 (MIB
is the s5agent). With this feature, the system can obtain the time from any RFC 2030-compliant
NTP/SNTP server.
Refer to Configuration — System Avaya Ethernet Routing Switch 4000 Series,
NN47205-500 for more information on SNTP.
About this task
You can configure the Network Time Protocol (NTP) servers for SNTP.
Procedure
1. Enable Global Configuration mode in ACLI:
enable
configure terminal
2. Enter the following command to configure the SNTP primary address:
sntp server primary address [<A.B.C.D> |
<primary_server_ipv6address>]
3. Enter the following command to configure the SNTP secondary address:
Configuring the switch using ACLI
36 Quick Start Configuration for Avaya ERS 4000 Series November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
