Avaya 4000 Series - Page 35

Table 11: snmp-server name command
Variable Value
<text> Specifies the SNMP system name value.
Enter an alphanumeric string of up to 255
characters.
Note:
On the console, the SNMP server name is
truncated. On the Web interface, the full
SNMP server name appears.
Use the data in the following table to use the snmp-server contact command.
Table 12: snmp-server contact command
Variable Value
<text> Specifies the SNMP system contact value.
Enter an ASCII string of up to 255
characters.
Use the data in the following table to use the snmp-server location command.
Table 13: snmp-server location command
Variable Value
<text> Specifies the SNMP system location value.
Enter an alphanumeric string of up to 255
characters.
Use the data in the following table to use the snmp-server host command.
Table 14: snmp-server host command
Variable Value
<host-ip> Specifies an IPv4 or IPv6 address for a host
intended to be the trap destination.
<community-string> If you are using the proprietary method for
SNMP, enter a community string that works
as a password and permits access to the
SNMP protocol.
Configuring system identification
Quick Start Configuration for Avaya ERS 4000 Series November 2013 35