Procedure
1. Enable Global Configuration mode in ACLI:
enable
configure terminal
2. Enable Simple Network Management Protocol (SNMP) server.
snmp-server enable
3. Set the read-only community name.
snmp-server community ro
Note:
Enter the community string two times.
If you have run the install script to set up the configuration information, the read-
only community name is already set.
4. Set the read-write community name.
snmp-server community rw
Note:
Enter the community string two times.
If you have run the install script to set up the configuration information, the read-
write community name is already set.
5. Set the system name.
snmp-server name "<text>"
6. Set the system contact.
snmp-server contact "<text>”
7. Set the location.
snmp-server location "<text>”
8. Configure SNMP host to add trap receiver to the trap-receiver table.
snmp-server host <host-ip> <community-string>
Variable definitions
Use the data in the following table to use the snmp-server name command.
Configuring the switch using ACLI
34 Quick Start Configuration for Avaya ERS 4000 Series November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
