shutdown [force][minutes-to-wait <1-60>] [cancel]
Variable definition
Use the data in the following table to use the .
Table 20: shutdown command
Variable Value
force Instruct the switch to skip the shutdown
confirmation prompt.
minutes-to-wait <1-60> Specify the number of minutes that pass
before the switch resets itself The default
wait time is 10 minutes.
cancel Cancel all scheduled switch shutdowns.
Reloading remote devices
Use this procedure to disable auto saving configuration changes, and safeguard against a
configuration error when you perform dynamic configuration changes on a remote switch. If
you make an error while configuring a remote switch that results in the loss of connectivity (for
example, an error in the IP address, VLAN, etc.), the reload loads the last saved configuration
to re-establish connectivity.
This procedure does temporarily disable auto-save functionality until the reload occurs.
Cancelling the reload returns auto-save functionality to any previous setting.
About this task
This procedure is intended to be used by system administrators to configure remote devices
and reset them when the configuration is complete. The configuration is not explicitly saved
after the reload command is issued. This means that any configuration changes must be
explicitly saved before the switch reloads
Caution:
You must perform a timed reload command before making dynamic configuration changes
to safeguard against the loss of remote connectivity.
Procedure
1. Log on to Privileged EXEC mode in ACLI:
enable
2. Enter the following command:
Shutting down and resetting a switch
Quick Start Configuration for Avaya ERS 4000 Series November 2013 53
To Next Page
Loading...
