Environmental requirement Avaya Virtual Services Platform 4000 models
Miscellaneous Operating
Considerations
• No heat sources such as hot air vents or direct sunlight near the
switch.
• No sources of severe electromagnetic interference near the switch.
• No excessive dust in the environment.
• An adequate power source is within 6 feet (1.83 meters) of the switch.
One 15-amp circuit is required for each power supply.
• At least 2 inches (5.08 centimeters) of clearance on each side of the
switch unit for ventilation.
• Adequate clearance at the front and rear of the switch for access to
cables.
Warning:
To avoid bodily injury from hazardous electrical shock and current, never remove the top of the
device. No user-serviceable components are inside. For a translation of this statement, see
Translations of safety messages on page 36.
Package contents
The following describes the components that are provided with each switch. If any components are
missing, contact the switch vendor.
1. Avaya Virtual Services Platform 4000 4450GTX-HT-PWR+ switch with one power supply
installed
2. Rack-mounting hardware that includes:
• Rack-mount brackets
• Screws to attach brackets to the switch
• Screws to attach the switch to the equipment rack
3. Rubber footpads
4. AC power cord with an IEC 60320 C16 connector. (Note: A power cord is not included for
the A variant of the switch.)
5. Documentation that includes the following:
a. Locating the latest software and product Release Notes (NN46251–106)
b. The Regulatory guide (NN46251–105)
c. The Quick Install guide (NN46251–306)
d. The China RoHS paper
Package contents
August 2014 Installing the Avaya Virtual Services Platform 4000 VSP4450GTX-HT-PWR+ 19
Comments? infodev@avaya.com
To Next Page
Loading...
