Port LED state indicators
This section describes the port LED state indicators by color and fluctuation cues.
Note:
Indicator states are applicable to the 4450GTX-HT-PWR+ model of VSP 4000 switches.
The following list describes the three port LEDs:
• Activity indicates the level of activity on the link.
• Link indicates the presence of an Ethernet link.
• Speed indicates the port speed (for example, 10 Mb/s, 100 Mb/s, 1000 Mb/s).
Table 17: RJ-45 Port LED state indicators
Label Color and Status Description
Speed/PoE+ Green, Blink The port is set to operate at 1000 Mb/s with PoE.
Green, Steady The port is set to operate at 1000 Mb/s without PoE+.
Amber, Blink The port is set to operate at 100 Mb/s with PoE+.
Amber, Steady The port is set to operate at 100 Mb/s without PoE+.
Amber, Green Pulse The port is experiencing a PoE+ error.
Off When the Link/Activity LED is green and the Speed LED is off,
the port is set to operate at 10 Mb/s for all models.
Link / Activity Green, Steady The link established but no data activity exists.
Green, Blink The link is established and data activity exists (the blink rate
indicates the level of activity).
Green, Slow Blink The software disabled the port.
Amber, Steady Port disabled.
Amber, Blink Port not used.
Off Not applicable.
Table 18: SFP/SFP+ transceiver Port LED state indicators
Label Color and Status Description
In Use Green, Blink Not applicable.
Green, Steady The SFP/SFP+ port and the transmit port are active.
Amber, Blink Not applicable.
Amber, Steady SFP/SFP+ Installed—TX Port Inactive
Off No SFP/SFP+ transceiver is present.
Link / Activity Green, Blink Activity exists on the port.
Green, Slow Blink Software disabled this port.
Installing the Avaya VSP 4000 4450GTX-HT-PWR+
34 Installing the Avaya Virtual Services Platform 4000 VSP4450GTX-HT-PWR+ August 2014
Comments? infodev@avaya.com
To Next Page
Loading...
