Connect power to the front panel
Connect the AC power cord to the front of the switch, and then connect the cord to an AC power
outlet. The following figure shows how to connect the AC power cord to the switch front panel.
Important:
The Avaya VSP 4000 series has no AC power switch. When you connect the power cord to a
suitable, energized AC power outlet, the switch powers up immediately.
Figure 5: Connecting AC power to the front panel
Warning:
Disconnecting the AC power cord is the only way to turn off AC power to the Avaya VSP 4000.
Always connect the AC power cord in a quickly and safely accessible location in case of an
emergency. For a translation of this statement, see
Translations of safety messages on
page 36.
Caution:
Before you unplug the AC power cord, always perform the following shutdown procedure. This
procedure flushes any pending data to ensure data integrity.
1. Enter the Privileged EXEC command mode:
enable
2. Shutdown the VSP 4000:
sys shutdown
3. When prompted, enter y to confirm system shut down.
4. Before you unplug the power cord, wait until you see the following message:
System Halted, OK to turn off power.
Installing the Avaya VSP 4000 4450GTX-HT-PWR+
30 Installing the Avaya Virtual Services Platform 4000 VSP4450GTX-HT-PWR+ August 2014
Comments? infodev@avaya.com
To Next Page
Loading...
