Switch LED state indicators
The following figure describes the main switch LED state indications provided by LED color and
fluctuation cues.
Note:
Indicator states are applicable to all models of VSP 4000 switches.
Table 16: Switch LED state indicators
Label Color and Status Description
PWR Green (solid) The switch is receiving power either from the primary or
secondary power supply. Normal operation.
Green (blinking) System is in reset.
Off The switch is not receiving power and not operating.
Status Green (solid) • During start-up: The power-on self-test (POST) is complete
and the switch is operating normally.
• After start-up: The switch is running the agent code
successfully.
Green (blinking) The switch is loading the agent software code.
Amber (solid) The switch encountered an error when running the diagnostic
software.
Amber (blinking) The switch is booting and running diagnostic software. Normal
activity during boot process.
Off The switch failed the power-on self-test (POST) or failed to load
the agent code.
RPS Green (solid) The switch is connected to a redundant power supply unit
(RPS) or a secondary external power supply, and is operating
normally.
Green (blinking) The switch is connected to a secondary power supply, but the
power input is disconnected.
Amber (solid) The power supply in slot 1 or slot 2 was removed after
operating.
Amber (blinking) The power supply in slot 1 or slot 2 is present, but not supplying
power to the switch.
Off No power to secondary power supply. The switch is not
connected to an RPS or secondary power supply. The RPS is
not supplying power, or the DC/DC module is not supplying
power..
Check Light Emitting Diode (LED) on the Avaya Virtual Services Platform 4000
August 2014 Installing the Avaya Virtual Services Platform 4000 VSP4450GTX-HT-PWR+ 33
Comments? infodev@avaya.com
To Next Page
Loading...
