3. Connect the terminating resistor to the SILC DSL. See Connecting the terminating
resistor to the SILC DSL on page 72.
4. Connect the ISDN BRI terminals to the DSL. See Connecting the ISDN BRI
terminals to the DSL on page 74.
5. Initialize the terminals. See Initializing an Avaya M5317TDX terminal on
page 77.
Connecting ISDN BRI terminals to the system on page 65 shows a typical DSL and multiple
ISDN BRI terminals connected to the system.
Connecting ISDN BRI terminals to the system
Connecting system cables to the cross-connect terminal
Each card slot equipped with a SILC or UILC requires one NE-A25B 25-pair connector
cable.
Installation procedures
ISDN Basic Rate Interface Installation and Commissioning March 2011 65
To Next Page
Loading...
