Page 54 - IP Office Integration
Page 54 DECT - Installation Manual
DECT Configuration Software 38HBKD0001SAH – Issue 14 (27th October 2003)
12. The Configuration menu will now look as follows (with DECT
handsets 201 and 202 as slaves of desktop phones 203 and 204
respectively):
13. On completion, click Apply and then Exit.
14. Select Yes to start the DECT service.
15. A small icon may appear in the task bar to indicate that the DECT
configuration is active.
Call Waiting Indication
When Call Waiting Indication is required, then both the master or slave
handsets must have the facility selected. Perform the following:
1. On both the master and slave handsets, dial *15.
Alternatively, you can set up the IP Office remotely by:
2. From Programs/IP Office, open the Manager application. The default
password for Administrator is Administrator, however this must be
changed as early as possible.
3. Open the Configuration Tree (File/Open). The default password for the
IP Office configuration is password, however this password must
changed as early as possible.
4. In the Configuration Tree, open User to display all available users.
5. For the analogue port extension number assigned to the slave DECT
handset, right click in the User icon and select Edit.
6. Select the Telephony tab and click the Call Waiting box. Click OK.
7. For the master handset, right click in the User icon and select Edit.
8. Select the Telephony tab and click the Call Waiting box. Click OK.
To Next Page
Loading...
