• qty=1 – Ethernet 1Gb 2-port 332T adaptor
• qty=2 – 800W power supplies
Related links
Physically connecting the new server on page 26
Physical system protection requirements
To properly ventilate the system, you must provide a minimum clearance of:
• 63.5 cm (25 in) in front of the rack
• 76.2 cm (30 in) behind the rack
Note:
You must ensure that no environmental hazards, such as, excessive heat, excessive humidity,
improper ventilation, or electromagnetic interference from proximate equipment interfere with
the operation of the server.
Related links
Physically connecting the new server on page 26
Checklist for installing the server in the rack
This installation checklist contains the principle steps that are necessary to install the server in the
rack. The notation in the Reference column is a section in the appropriate HP document that
contains the step-by-step procedures. Where applicable, additional information and clarifications
appear in the Avaya recommendation column. Perform each task in the order specified.
Note:
Avaya customers are required to have a monitor and USB keyboard available for server
maintenance.
No. Task Reference Avaya recommendation
1 Observe safety
warnings.
User Guide:
Installing the
server into the
rack.
2 Examine contents
of shipping
container (Avaya
provided
equipment).
User Guide:
Identifying the
contents of the
server shipping
carton
• Server
• Rail Kit
• Printed setup documentation
• Rack mounting hardware kit and documentation
3 Examine
installation
environment
(customer
User Guide:
Optimum
Environment
When installing the server in a rack, select a location that
meets the environmental standards.
Table continues…
Physically connecting the new server
August 2017 Installing the Avaya Equinox Streaming and Recording Server 43
Comments on this document? infodev@avaya.com
To Next Page
Loading...
