EasyManua.ls Logo

Avaya S8700 - Page 243

Avaya S8700
700 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PKT-INT (Packet Interface)
Issue 1 May 2002
8-939555-233-142
Private Loop-around Tests (#885)
This test requests the Packet Interface circuit to execute its two private
loop-around tests: Level-2 Loop Around, and Broadcast Path Loop Around.
These tests verify the health of the circuit packs packet-bus interface, as well as
the translation RAM, inward and outward bound data paths, parity indications and
CRC calculations.
Level-2 (LAP-D) Link Loop Around
LAP-D is a link level protocol that is used for all system links. This test
verifies the health of the processing of these links.
Broadcast Link Loop Around
Each ISDN-BRI port has two associated broadcast signaling links, one for
call control and one for maintenance and management. Since these links
have separate routing circuitry from the Level-2 Loop Around, this test
forces a CRC error to verify the CRC hardware associated with the
broadcast data path.
These tests are also run as part of the reset tests. If the Level-2 Loop-Around test
fails as background tests, a fatal error message is sent to the Packet Interface
circuits maintenance software, and the Packet Interface circuit is put in the
out-of-service state. Therefore, repair procedures associated with Abort
Code 1137 (out of service) would normally follow failures of the level-2 test.
2 FAIL The Flash memory checksum test failed. The circuit pack may still be
operational, but will fail if a reset is executed.
1. Retry the command.
2. If the same error code occurs:
a. If the Packet Interface circuit is on the standby IPSI, replace that circuit
pack.
b. If the Packet Interface circuit is on the active IPSI, enter set
ipserver-interface to perform a planned IPSI interchange.
c.
3 FAIL The Boot PROM memory Checksum test and the FLash memory checksum
test have both failed. Follow the steps listed for FAIL Error Codes 1 and 2.
PASS The circuit packs firmware is in a proper state. If problems are still reported on
the circuit pack, check for errors on the Private Loop-around test (#885) and
Maintenance Loop-Around test (#886).
Table 8-394. Test #884 Memory Checksum Test Continued
Error
Code
Test
Result Description / Recommendation
Continued on next page

Table of Contents

Other manuals for Avaya S8700

Related product manuals