From the endpoint interface
From the web interface
Figure 79: Choices of audio input to configure
Field Description
General Enable automatic disabling of some audio inputs depending on
which audio inputs are connected.
POD1/POD2
Configure the port for the Microphone Pod.
Digital Audio
Configure the port when connecting a third-party digital
microphone via its mini-TOSlink connector.
Analog Audio
Configure the port when connecting the One-way Microphone
Pod or a third-party analog microphone via its 3.5mm jack.
HD1/HD2 (only XT7000
Series)
Select to configure sound from HDMI devices.
USB Camera Configure the USB port for audio of a built-in microphone from a
USB camera. If you connect another audio input with echo
cancellation enabled, the audio from the USB camera is disabled.
USB Microphone Configure the USB port for audio of a dedicated USB microphone or
headset. However, any connected Microphone Pods are disabled
by default if Audio Inputs Management is set to Automatic. To
change this, set I/O connections > Audio - Input > General >
Audio Inputs Management to Manual.
3. Set the fields as required.
Initial Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 122
Comments on this document? infodev@avaya.com
To Next Page
Loading...
