Field Name Setting
Media Server and Scopia Desktop Server, endpoints like XT Series and
other network devices like network routers.
Important:
It is essential that MTU settings are defined with identical values on
this device and all network components, including Equinox Solution
components and your generic network components like switches
and routers. Only create custom MTU settings if the rest of your
network has the same settings.
If you or a remote endpoint transmit at a larger MTU size, packets are
dropped or fragmented. To avoid packet loss or fragmentation, ensure all
network components use the same MTU size. The default MTU size is
1360. For IPv4, set the MTU between 576-1500. For IPv6, set it between
1280-1500.
Speed/Duplex mode Set the speed and transition mode as follows:
• Automatic: The XT Series selects the speed and duplex mode. We
recommend this default mode.
• Auto - up to 100/Full, Auto - up to 100/Half, Auto - up to 10/Full,
Auto - up to 10/Half: Semi-automatic modes with a specified
maximum.
• Manual: Configure the speed and duplex mode manually for your
network and the remote endpoints' settings.
Speed Select the speed of the network port: 10 or 100 Mbps (manual
configuration only).
Duplex mode Select the data transmission mode that is defined for your network router
or switch, either duplex or half-duplex mode (manual only).
6. From the web interface only, select Save.
7. To tag the XT Series to belong to a particular virtual network (VLAN) ID, select GLAN1/
GLAN2 > VLAN.
8. Set the fields as described in the following table:
Table 33: Designating a VLAN tag
Field Name Setting
Enable Select Yes if your network is split into virtual networks (VLANs) and you
want to assign the XT Series to one of them.
Id Enter the ID of the VLAN to which this unit belongs, between 1 and 4094.
9. To configure the XT Series for 802.1x compliant authentication, select GLAN1/GLAN2 >
802.1x.
10. Set the fields as described in the following table:
Configuring Advanced Network Settings
January 2017 Avaya Scopia
®
XT Series Deployment Guide 137
Comments on this document? infodev@avaya.com
To Next Page
Loading...
