Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the gatekeeper settings. From the XT Series web interface, select Administrator
Settings > Protocols > H.323 > General. From the endpoint's main menu, select
Configure > Advanced > Protocols > H.323.
From the endpoint interface
From the web interface
Figure 91: Configuring H.323 settings from the web interface
2. Set the fields as described in Table 37: Configuring H.323 settings on page 142.
Table 37: Configuring H.323 settings
Field Name Description
H.323 Name Enter the H.323 alias of this endpoint, used to register the unit with
the gatekeeper. In H.323 calls, this name is displayed on
participant's monitors (for example: John-Smith, or 9th-Floor-Room,
or NY-Office).
E.164 Enter this endpoint's E.164 dial number.
Gatekeeper Address You can use a DNS name to configure the gatekeeper address.
This allows dynamic resolution of the gatekeeper IP address and in
the case of multiple returned addresses, the endpoint registers to
the first available address.
3. From the web interface only, select Save.
4. Select H.323 > Gatekeeper.
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 142
Comments on this document? infodev@avaya.com
To Next Page
Loading...
