Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the call settings. From the XT Series web interface, select Administrator Settings >
Calls > Preferences > General. From the endpoint's main menu, select Configure >
Advanced > Calls > Preferences > General.
From the endpoint interface
From the web interface
Figure 93: Configuring general call settings
2. Set the fields as described in the following table.
<auto > is the default setting. It indicates that the system tries to choose the settings that
best suit the local situation.
Table 40: Configuring bandwidth settings of a call
Field Name Description
IP > Rate (K) Sets the maximum bitrate used for a single point-to-point call.
Audio Coding Sets the preferred audio codec that the system tries to send. The
remote system must support the same codec for a successful
connection.
Table continues…
4
XT only
4
XT only
4
XT only
4
XT only
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 146
Comments on this document? infodev@avaya.com
To Next Page
Loading...
