Field Name Description
Video Coding Sets the preferred video codec that the system tries to send, if the
remote system supports the same codec.
H.239 or BFCP are not applicable to web collaboration.
DualVideoCoding Sets the resolution for H.264 content video.
Use manual DualVideo
bandwidth
If set to Yes allows to change bandwidth used for H.264 content
and live video (DualVideo/Live bandwidth).
DualVideo/Live bandwidth Sets more bandwidth on Live Video or H.264 Content.
ISDN > Rate (K) Sets the maximum call rate that the system uses for any ISDN call.
3. From the web interface only, select Save.
4. Access the bandwidth limits for each network port. From the XT Series web interface, select
Administrator Settings > Networks > GLAN1/GLAN2 > Bandwidth. From the endpoint's
main menu, select Configure > Advanced > Networks > GLAN1/GLAN2 > Bandwidth.
Figure 94: Setting bandwidth limits for each network port
5. Set the fields as described in the following table:
Table 41: Configuring bandwidth settings of a call
Field Name Description
Enable Select Yes to enable limiting bandwidth for this network port.
Max. Bandwidth Rx (KB) Enter the incoming bandwidth limit for traffic on this network port,
measured in kilobytes (not kilobits) per second (KBps).
Max. Bandwidth Tx (KB) Enter the outgoing bandwidth limit for traffic on this network port.
Related links
Advanced Configuration of the XT Series on page 128
Setting Call Bandwidth in XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 147
Comments on this document? infodev@avaya.com
To Next Page
Loading...
